New Products: More Shields For ESPea

BMP280 shield for ESPea. The BMP280 sensor can measure barometric pressure and temperature with very good accuracy. This shield is good match with ESPea, ESPea32. It also has nice size. Buy Link ESPea Relay Shield for ESPea. This is the ESPea Relay Shield, an add-on board that allows your ESPea to control higher voltage and current loads…

Details

New Product: OLED Shield For ESPea

128×64 pixels OLED Shield with I2C. It adds a 128×64 monochrome OLED to ESPea main board. The OLED uses only the two I2C pins on the ESPea, and you can pretty much stack it with ESPea, even ones that use I2C since that is a shared bus. Buy Link. Prototype Shield For ESPea is also…

Details

New example code for Cactus Micro from IOTLink

The following example in C uses the REST interface with a secure SSL configuration to exchange AP configuration with the onboard ESP8266. The board is a Cactus Rev 2. The sketch updates the status every 60 seconds in the IoTLink dashboard. click on Learn More, then Examples, there are examples for Cactus rev 2 using…

Details

New Product Available: ESPea Dev Board

ESPea is a new Wi-Fi development board from AprilBrother technologies. It uses the ESP8266EX chipset as the main micro-controller and supports the Arduino environment. At the ESPea’s heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack.…

Details

New Product: BLEPad available

BLEPad – The BLEPad is an Arduino compatible microcontroller development board based on the ATmega32U4 IC with Bluetooth 4.0. a.k.a. Bluetooth Low Energy (BLE), built in. You can choose board type LilyPad Arduino USB from Arduino IDE to start programming. It’s the easiest way to get Bluetooth 4.0 in your project!